|
Post by lawlacan on Mar 27, 2004 20:54:59 GMT -5
Hi,
I need some advice on how to remove the extra plastic (resin) on this kind of kit. Has anyone ever made one od this kits?
I have the kit for sometime now and still haven't started painting or making it. I am just being cautious I think.
Any help is appreciated.
|
|
|
Post by waruderos on Mar 28, 2004 3:35:14 GMT -5
Most resin flash usually breaks off cleanly from the cast parts of a resin model, just using your fingers. Any flash that is too thick/strong to easily break away in this manner can be trimmed down with nail clippers, then a nail-file to bring the remaining seam very close to the surface of the model. Finally, that remaining seam is smoothed into the model surface with very fine grit sandpaper. (wet sanding is the safest way to sand resins, to keep the resin dust from becoming airborn).
|
|
|
Post by lawlacan on Mar 28, 2004 11:33:18 GMT -5
Thanks...I will try that
|
|