Post by gt3ian on Aug 9, 2009 18:08:29 GMT -5
This time is modifying the fists.
The fists are not that good, therefore I decide to make some changes.
First of all, trim the ball joints from the arms.
Drill a hole on both arms in the center.
Secure the soft plastic cup to the arm by a screw. Plastic cup are from the 1/144 Turn A Gundam model.
I chose the fists from the Master Grade GP-03S Gundam, cuz the fists from 1/144 model are way too small. The screw took out some spaces from the plastic cup, so I trimmed the ball joints from the fists, it's about 1/3 of the sphere.
It is lots of fun to play with!
Donnie Yen!!!
Comparison with the original.
robotjapan.proboards.com/index.cgi?board=fancustom&action=display&thread=15028
Check the above link to see how I made it taller.
It is quite match with Soul of Chogokin.
To be continue .....
The fists are not that good, therefore I decide to make some changes.
First of all, trim the ball joints from the arms.
Drill a hole on both arms in the center.
Secure the soft plastic cup to the arm by a screw. Plastic cup are from the 1/144 Turn A Gundam model.
I chose the fists from the Master Grade GP-03S Gundam, cuz the fists from 1/144 model are way too small. The screw took out some spaces from the plastic cup, so I trimmed the ball joints from the fists, it's about 1/3 of the sphere.
It is lots of fun to play with!
Donnie Yen!!!
Comparison with the original.
robotjapan.proboards.com/index.cgi?board=fancustom&action=display&thread=15028
Check the above link to see how I made it taller.
It is quite match with Soul of Chogokin.
To be continue .....
