|
Post by purplehaze on Mar 4, 2005 18:57:41 GMT -5
lately when i try to pose my MG freedom the wings tend to fall apart, i want to glue the wings together yet im afraid i might mess this up, could anybody give suggestions on what to glue and what kind of glue to use for the wings
|
|
|
Post by does_it_matter! on Mar 4, 2005 19:43:08 GMT -5
How does it fall apart? I never had that kind of thing happening to me so would you mind explaining abit.
Only problem I have with my freedom is the waist, is there a same problem with yours?
Anyway, it's better not to glue anything yet until you can show some pictures or at least describe what part of the wing is the one causing problem.
|
|
|
Post by heavyarmscustom on Mar 5, 2005 17:45:31 GMT -5
D_I_T Is your FG waist a ball joint? as the FG is one one the MG I have not gotten yet (went crazy for the MG ball cannons) if it is a baal and socket joint all you need to do is put a drop of super glue or a clear cote of any kind and move the joint around as the S_glue /clear dries in the socket making a tighter fit. as far as the Wings I would glue the wing parts together. adding extra tention to the parts. then go for the glue/clear method on the joints
|
|
|
Post by purplehaze on Mar 6, 2005 1:05:28 GMT -5
the ball joint has nothing to do with the freedom gundam, the only problem is when i unfold the cannons the peices of the wings tend to pop off and i have to resnap the wing parts back together each wing is a 20 piece construction in itself
|
|
|
Post by heavyarmscustom on Mar 6, 2005 6:34:26 GMT -5
P.H. if you had read my post, the ball joint part was for Does_it_matter(D_I_m not T missed the M Key) but you (P.H.) seem too have to glue the parts together and hope for the best. you may try cutting the posts shorter, not to short. but I have found on some gundams the shorter posts have worked better just cut with plaz-snips and round the edge.
hope that works
|
|